ZCI V2/V3 Integration Cylinder Head

These are multi use V2/V3 cylinder heads from ZCI. The difference between the TM spec V2 and V3 cylinder heads is a very slight sizing of the locking holes. By making the holes slightly larger a cylinder head that fits both types can be made, since the tabs should not be supporting any load the larger holes don't effect strength negatively. Colors of this batch are metallic gray, red, green and blue.

Specifications:
Nozzle tube diameter: 5.346mm
Nozzle tube length: 16.24mm

Note: These are compatible with ZCI, HC, SHS, and Core nozzles but not Lonex due to them being too tight.

Note 2: The impact pads on these are not always glued on well enough so if you aren't replacing it with a Sorbo Pad (I would recommend the Sorbo Pad instead) it would be safest to reglue the pad on with some CA after better surface prep on the rubber and aluminum.